Sound Surgeon

I found an old price on my TV. My view fell on the TDA2030A microchemical. I've known for a long time now that the "TDA" microschems are low-frequency surgeons, and I've decided to see her on the Internet. In fact, we're going to collect this pattern:

We're gonna need:
TDA2030A.
Condensers 0, 1mqf 3 grand.
2200mqf 25v electrolytic 2 grand.
Resistor 2.2 om.
Restors are 222 grand.
Resistor 680.
Condensator 22mqf 25v electrolytic.
Condenser 4, 7mcf.
Corps, switch, wire, radiator, tulips.

My goal was to create a forcer without using a rouble. All the details, except the hull, I've been falling off the various charges.
Collecting the force can be done in a variety of ways, in this case, I collect the hinged cord by wire. Since many findings are connected to the ground, I recommend that a wire be made.

Let's go to the rations. I advise you to put it through a rations! Attention! The findings of the microchem are counted on the left to the right. At the same time, the markings and conclusions directed at you.

After you've assembled the whole scheme, you need to check it out, connect the dynamics and, first, check the plug.

If it works, we'll start next phase.
I bought a ready body in the Electic. Radiator's better off outside for the best cooling. Set up the radiator, the dispensers, the power lines, the power switch.

The force holder shall have the following characteristics:
Catering voltages: ±4.5 to ±25 V
Output capacity.18 W
Nominal frequency range.20 - 80.000 Hz